|
 SEAMLESS Set-up
Instructions |
|
| 1. PANEL ASSEMBLY |
| 1-Do NOT unfold panels. |
| 2-Stack mid stripe sections (if
included) onto bottom section by inserting nylon pins into bottom section as shown. |
| 3-Stack top section onto the
mid=stripe (or bottom section if there is no mid stripe) in the same manner. |
 |
| Panels can be positioned by
holding bottom of display and fanning out the panels as indicated by the arrows. Never
straighten the system all the way out. You must have at least two panels angled 45 degrees
or more to the rest of the system in order to maintain stability. |
|
| 2. CURVE
ASSEMBLY |
| To assemble curves, swing
aluminum brackets so that they are at a right angle to the curve (as shown). Then
insert the nylon pin from the bracket into the opposite bracket and secure with the velcro
hook tape on the outside of these brackets. |
 |
|
| 3. ATTACHING
CURVES |
| Attached curves to panels by
sliding open-end of curved unit over the edge of the bottom panel. It may be helpful
to slide it in a downward motion. Middle curved sections may be attached in the same
manner, taking care to insert pin into the corresponding hold of the bottom unit and
tucking in flap behind bottom curved end unit. Repeat this procedure for the top end curve
section. Repeat on other side of unit. |
 |
|
| 4. ATTACHING
COMPONENTS |
| ALCOVE COUNTER
INSTRUCTIONS |
 |
After setting up display system as shown,
slip the four shelf brackets between mid-stripe and lower panel as shown. Joint the two
pieces of the countertop by fastening spring latches. Place countertop assembly on shelf
brackets. Attach doors beneath countertop at opposite ends. Place modesty panel between
sets of doors. |
SHELVING Aluminum shelving fits in between panels and comes either slanted
or straight. Also available is plastic shelving which attaches to unit with velcro hook
tape. |
 Stabilizer bars and lights
fit over the top of the display. Stabilizer bars are plastic channels that help keep
the display stabile at the hinges where a flat backwall is desired. |
HEADERS
(back side shown below)
Headers that are 60" or longer are in two
parts. Connect the header pieces by latching them together from the back. To place on
display, slide pins behind the wall of panels and position header as far forward or back
as you need. (The angle of the panels will affect this.) |
|
|
| PENINSULA COUNTER
INSTRUCTIONS |
 |
- Attach front quarter round panels to each other with the
wood spine provided.
- Add back (flat section) to joined quarter rounds by
sliding this panel (40"h x 19"w) into u channels.
- Slip two shelf brackets between mid stripe and lower panel
on display backwall.
- Position half-round and place countertop to rest on
brackets and half round.
* If included, attached the modesty panel beneath the
countertop. On the opposite side, attach the door and 7" fill panel. |
|
 |
Headers (both halves) should be
placed face to face inside the foam tray provided. Foam
Tray
Cardboard
Curve (place fabric side down)
Curve (place fabric side down)
Curve (place fabric side down)
Curve (place fabric side down)
Top panels (accordian folded)
Case |
|
|
